Journal of
Chemical Engineering and Materials Science

  • Abbreviation: J. Chem. Eng. Mater. Sci.
  • Language: English
  • ISSN: 2141-6605
  • DOI: 10.5897/JCEMS
  • Start Year: 2010
  • Published Articles: 97

Full Length Research Paper

Remediation of a simulated petroleum polluted water using pulverised used: Water sachet (Polyethylene)

Edoga M. O
  • Edoga M. O
  • Department of Chemical Engineering, Federal University of Technology, Minna, Niger State, Nigeria.
  • Search for this author on:
  • Google Scholar
Kovo A. S.
  • Kovo A. S.
  • Department of Chemical Engineering, Federal University of Technology, Minna, Niger State, Nigeria.
  • Search for this author on:
  • Google Scholar
Oledibe M. C.
  • Oledibe M. C.
  • PRS, Ministry of Petroleum Resources, Abuja, Nigeria.
  • Search for this author on:
  • Google Scholar


  •  Received: 17 February 2014
  •  Accepted: 03 March 2014
  •  Published: 24 July 2014

Abstract

The potential of using used-water-sachets, a synthetic polymeric waste, which is not only readily available but indiscriminately littered around Nigerian urban and rural areas, as an adsorbent in removal of oil spilled on water was investigated. Used-water-sachets, a waste generated all over the country, has been converted into a low cost adsorbent. The sachets were collected, pretreated and pulverised to adsorb crude oil from water at various time intervals. The study examined the removal efficiency of pulverized used-water-sachet polyethylene (PUWSP) of crude oil spilled on the surface of water. It was observed that PUWSP was capable of adsorbing the artificially spilled crude oil on the water surface. The crude oil was approximately 100% cleaned up within 3 h time interval.

 

Key words: Crude oil, sachet polyethylene, pulverized used-water.

Copyright © 2024 Author(s) retain the copyright of this article.

This article is published under the terms of the Creative Commons Attribution License 4.0

Back to Vol. 5 No. 3
Back to articles
SUBSCRIBE TO RSS
SUBMIT MANUSCRIPT
CONFERENCES