Journal of
Mechanical Engineering Research

  • Abbreviation: J. Mech. Eng. Res.
  • Language: English
  • ISSN: 2141-2383
  • DOI: 10.5897/JMER
  • Start Year: 2009
  • Published Articles: 119

Full Length Research Paper

Adhesive bonded single lap and over-lap joints of C/C, C/C-SiC composites and titanium alloy

  V. K. Srivastava* Department of Mechanical Engineering, Institute of Technology, Banaras Hindu University, Varanasi- 221005, India.and Shraddha Singh        
Department of Mechanical Engineering, Institute of Technology, Banaras Hindu University, Varanasi- 221005, India.
Email: [email protected]

  •  Accepted: 28 March 2011
  •  Published: 31 May 2011

Abstract

 

Carbon-carbon (C/C), carbon-carbon-silicon carbide (C/C-SiC) composites and titanium alloy substrates were bonded in single lap and overlap joints with phenolic resin to study the differences in joint strength of two similar and dissimilar materials under shear load. The results indicate that the bonding strength of single lap joint of C/C, C/C-SiC is more than the other ceramic and titanium alloy, whereas Ti-Ti bonded over lap joints show remarkable improvement in similar and dissimilar substrates. Scanning electron microscope (SEM) describes the surface morphology and indicates the bonded zone fractured in the form of thin film which shows strong interaction in between two surfaces.

 

Key words: C/C composite, C/C-SiC composite, titanium alloy, adhesive joints, bonding strength.

Copyright © 2024 Author(s) retain the copyright of this article.

This article is published under the terms of the Creative Commons Attribution License 4.0

Back to Vol. 3 No. 5
Back to articles
  • Articles on Google by:
SUBSCRIBE TO RSS
SUBMIT MANUSCRIPT
CONFERENCES